back to top Back to top

Help Pages

Marquees

3m Marquees

4m Marquees

6m Marquees

9m Marquees

Walkways

Packages

Linings

Heating

Accessories

Stacking, Storing and transporting marquee dance floors

The design of marquee dance floors are all very similar, battens across the back and small battens/teeth at one end. This enables the dance floor to lay nicely and each board to lock in with each other:

back of dance floor board

Back of dance floor board

There are a few issues with storing and transporting dance floors. If not stored correctly the surface can get damaged, if not stacked correctly the pile can be unstable (a pile of dance floor tipping over in a van is not good for the heart-rate) and a damp dance floor left in store can become mouldy or warped.

So this is what we did for all of our dance floors:

dance floor in transit

We would always try to transport dance floor boards face-to-face, that way you protect the surface. Carrying them in pairs helps this process but it depends on the muscle power available.

In transit we would stagger the pairs of boards so one pair had teeth at one end whilst the next pair had teeth at the other (see diagram above), this way the dance floor is nice and compact but still laying flat.

dance floor in storage

When storing the boards away we would use a slightly different system of putting the boards batten on top of batten (it’s not incredibly clear by my dodgy diagram but all battens should line up on top of each other!). The idea of this is that the boards are still flat and still stacked surface-to-surface but the larger gap allows more air around the wood -this allows the wood to dry out and ultimately will last longer before needing replacement.

Thanks for reading

Spencer